Tuning the Display Feature

This section describes how to tune the Display feature to control the output of a DC8200.

Before you begin

Make sure:
  • The details view shows the settings of the Display feature for a DC8200 project.

    For information about how to show the settings in the details view, see Tuning a DC8200 Feature.

    Figure 1. Details View When the Display Feature is Selected

  • The VTunerClient is connected to a VTunerServer that works with a DPU running on a CModel.

    For information about how to set up a connection to a VTunerServer, see Setting Up a Connection to a VTunerServer.

Procedure

  1. In the upper-left corner, select the Enable Display check box to enable the output of the DC8200.
  2. From the Display Size drop-down list, select the output resolution and refresh rate.
  3. From the Display Type drop-down list, select the output interface type.
  4. From the Display Format drop-down list, select the output color format.

Results

  • The tuning results are printed in the Console view in real time.
  • The image displayed on the VTunerServer side is updated.