Tuning the Color Management Feature

This section describes how to tune the Color Management feature to control the color management module in the third party IP group G2 within a DC8200. This feature supports tuning six range pairs and two ranges in each pair.

Before you begin

Make sure:
  • The details view shows the settings of the Color Management feature for a DC8200 project.

    To tune the Color Management feature, you need to choose Display > Color Management > Range Pair in the Features view. For more details, see Tuning a DC8200 Feature.

    Figure 1. Details View When a Range Pair Under Color Management is Selected

  • The VTunerClient is connected to a VTunerServer that works with a DC8200.

    For information about how to set up a connection to a VTunerServer, see Setting Up a Connection to a VTunerServer.

Procedure

  1. Clear the Bypass check box to enable the range pair.
  2. Select or clear the Use 2 Range Together check box.
  3. If Use 2 Range Together is selected, specify color configurations on the Use 2 Ranges Together tab.
  4. If Use 2 Range Together is cleared, specify color configurations on the 1st Range and 2nd Range tabs.

Results

  • The tuning results are printed in the Console view in real time.
  • The image displayed on the VTunerServer side is updated.